View all text of Subjgrp 561 [§ 51.1435 - § 51.1436]
§ 51.1436 - Size classifications for pieces.
The size of pecan pieces in a lot may be specified in accordance with one of the size classifications shown in table 1 to this section. Sizes are measured using a round-hole screen.
(a) Tolerances for size of pieces. In order to allow for variations incident to proper sizing, tolerances are provided for pieces in a lot which fail to meet the requirements of any size specified. The tolerances, by weight, are as follows:
(1) U.S. Extra Fancy pieces and U.S. Fancy pieces. Not more than 15 percent of the lot may fall outside of the size range in Table 1 to this section. Further, not more than 1 percent of the pieces, excluding Topping Pieces and Granules, may pass through an eight sixty-fourths of an inch round hole screen.
(2) U.S. Choice pieces. Not more than 20 percent of the lot may fall outside of the size range in Table 1 to this section. Further, not more than 2 percent of the pieces, excluding Topping Pieces and Granules, may pass through an eight sixty-fourths of an inch round hole screen.
(3) U.S. Standard pieces. Not more than 25 percent of the lot may fall outside of the size range in table 1 to this section. Further, not more than 2 percent of the pieces, excluding Topping Pieces and Granules, may pass through an eight sixty-fourths of an inch round hole screen.
(b) [Reserved]
Table 1 to § 51.1436
Size classification | Maximum diameter
(will pass through round opening of the following diameter) | Minimum diameter
(will not pass through round opening of the following diameter) | Extra-Large Pieces | No limitation | 32/64 inch. | Large Pieces | 32/64 inch | 24/64 inch. | Halves and Pieces | No limitation | 20/64 inch. | Medium Pieces | 24/64 inch | 16/64 inch. | Small Pieces | 16/64 inch | 12/64 inch. | Topping Pieces | 12/64 inch | 8/64 inch. | Granules | 8/64 inch | 4/64 inch. |
---|
In lieu of the size classifications in this table, the size of pieces in a lot may be specified in terms of minimum diameter, or as a range described in terms of minimum and maximum diameters expressed in sixty-fourths of an inch.