Collapse to view only § 20305. Inspection of mail cars
- § 20301. Definition and nonapplication
- § 20302. General requirements
- § 20303. Moving defective and insecure vehicles needing repairs
- § 20304. Assumption of risk by employees
- § 20305. Inspection of mail cars
- § 20306. Exemption for technological improvements
§ 20301. Definition and nonapplication
(a)Definition.—In this chapter, “vehicle” means a car, locomotive, tender, or similar vehicle.
(b)Nonapplication.—This chapter does not apply to the following:
(1) a train of 4-wheel coal cars.
(2) a train of 8-wheel standard logging cars if the height of each car from the top of the rail to the center of the coupling is not more than 25 inches.
(3) a locomotive used in hauling a train referred to in clause (2) of this subsection when the locomotive and cars of the train are used only to transport logs.
(4) a car, locomotive, or train used on a street railway.
(Pub. L. 103–272, § 1(e), July 5, 1994, 108 Stat. 881; Pub. L. 104–287, § 5(52), Oct. 11, 1996, 110 Stat. 3393.)
§ 20302. General requirements
(a)General.—Except as provided in subsection (c) of this section and section 20303 of this title, a railroad carrier may use or allow to be used on any of its railroad lines—
(1) a vehicle only if it is equipped with—
(A) couplers coupling automatically by impact, and capable of being uncoupled, without the necessity of individuals going between the ends of the vehicles;
(B) secure sill steps and efficient hand brakes; and
(C) secure ladders and running boards when required by the Secretary of Transportation, and, if ladders are required, secure handholds or grab irons on its roof at the top of each ladder;
(2) except as otherwise ordered by the Secretary, a vehicle only if it is equipped with secure grab irons or handholds on its ends and sides for greater security to individuals in coupling and uncoupling vehicles;
(3) a vehicle only if it complies with the standard height of drawbars required by regulations prescribed by the Secretary;
(4) a locomotive only if it is equipped with a power-driving wheel brake and appliances for operating the train-brake system; and
(5) a train only if—
(A) enough of the vehicles in the train are equipped with power or train brakes so that the engineer on the locomotive hauling the train can control the train’s speed without the necessity of brake operators using the common hand brakes for that purpose; and
(B) at least 50 percent of the vehicles in the train are equipped with power or train brakes and the engineer is using the power or train brakes on those vehicles and on all other vehicles equipped with them that are associated with those vehicles in the train.
(b)Refusal To Receive Vehicles Not Properly Equipped.—A railroad carrier complying with subsection (a)(5)(A) of this section may refuse to receive from a railroad line of a connecting railroad carrier or a shipper a vehicle that is not equipped with power or train brakes that will work and readily interchange with the power or train brakes in use on the vehicles of the complying railroad carrier.
(c)Combined Vehicles Loading and Hauling Long Commodities.—Notwithstanding subsection (a)(1)(B) of this section, when vehicles are combined to load and haul long commodities, only one of the vehicles must have hand brakes during the loading and hauling.
(d)Authority To Change Requirements.—The Secretary may—
(1) change the number, dimensions, locations, and manner of application prescribed by the Secretary for safety appliances required by subsection (a)(1)(B) and (C) and (2) of this section only for good cause and after providing an opportunity for a full hearing;
(2) amend regulations for installing, inspecting, maintaining, and repairing power and train brakes only for the purpose of achieving safety; and
(3) increase, after an opportunity for a full hearing, the minimum percentage of vehicles in a train that are required by subsection (a)(5)(B) of this section to be equipped and used with power or train brakes.
(e)Services of Association of American Railroads.—In carrying out subsection (d)(2) and (3) of this section, the Secretary may use the services of the Association of American Railroads.
(Pub. L. 103–272, § 1(e), July 5, 1994, 108 Stat. 881.)
§ 20303. Moving defective and insecure vehicles needing repairs
(a)General.—A vehicle that is equipped in compliance with this chapter whose equipment becomes defective or insecure nevertheless may be moved when necessary to make repairs, without a penalty being imposed under section 21302 of this title, from the place at which the defect or insecurity was first discovered to the nearest available place at which the repairs can be made—
(1) on the railroad line on which the defect or insecurity was discovered; or
(2) at the option of a connecting railroad carrier, on the railroad line of the connecting carrier, if not farther than the place of repair described in clause (1) of this subsection.
(b)Use of Chains Instead of Drawbars.—A vehicle in a revenue train or in association with commercially-used vehicles may be moved under this section with chains instead of drawbars only when the vehicle contains livestock or perishable freight.
(c)Liability.—The movement of a vehicle under this section is at the risk only of the railroad carrier doing the moving. This section does not relieve a carrier from liability in a proceeding to recover damages for death or injury of a railroad employee arising from the movement of a vehicle with equipment that is defective, insecure, or not maintained in compliance with this chapter.
(Pub. L. 103–272, § 1(e), July 5, 1994, 108 Stat. 882.)
§ 20304. Assumption of risk by employees
An employee of a railroad carrier injured by a vehicle or train used in violation of section 20302(a)(1)(A), (2), (4), or (5)(A) of this title does not assume the risk of injury resulting from the violation, even if the employee continues to be employed by the carrier after learning of the violation.
(Pub. L. 103–272, § 1(e), July 5, 1994,
§ 20305. Inspection of mail cars
The Secretary of Transportation shall inspect the construction, adaptability, design, and condition of mail cars used on railroads in the United States. The Secretary shall make a report on the inspection and submit a copy of the report to the United States Postal Service.
(Pub. L. 103–272, § 1(e), July 5, 1994, 108 Stat. 883.)
§ 20306. Exemption for technological improvements
(a)General.—Subject to subsection (b) of this section, the Secretary of Transportation may exempt from the requirements of this chapter railroad equipment or equipment that will be operated on rails, when those requirements preclude the development or implementation of more efficient railroad transportation equipment or other transportation innovations under existing law.
(b)Conditions for Exemption.—The Secretary may grant an exemption under subsection (a) of this section only on the basis of—
(1) findings based on evidence developed at a hearing; or
(2) an agreement between national railroad labor representatives and the developer of the new equipment or technology.
(Pub. L. 103–272, § 1(e), July 5, 1994, 108 Stat. 883.)